The short version of reversed-phase HPLC fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-09-13. Anything still debated is marked as such rather than presented as settled.
The published literature is dominated by a small number of research groups, much of it in Russian-language journals, and independent replication outside those groups is limited. Studies are typically small, use cultured cells or rodent models, and report endpoints that differ between papers, which makes comparison difficult. Large randomised human trials have not appeared in the indexed literature. Questions about absorption, distribution and clearance are therefore still treated as open in reviews that mention the compound.
Epitalon is a synthetic tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. Its design traces to epithalamin, a peptide fraction prepared from bovine pineal gland extracts that researchers in Saint Petersburg began investigating in the 1970s. The compound has a molecular formula of C14H22N4O9 and a nominal molecular mass near 390 daltons. It holds no approved drug status in the United States or the European Union, and material sold under this name is generally offered as a research chemical rather than a finished pharmaceutical product.
Proposed mechanisms centre on cell-culture observations rather than a defined receptor interaction. Several reports describe increased expression of the telomerase catalytic subunit after exposure of cultured human cells, and the authors attributed the effect to short peptide fragments entering the nucleus and influencing gene transcription. No receptor for the tetrapeptide has been identified, and the free peptide is expected to be degraded rapidly by plasma peptidases. Whether any measurable fraction reaches intact tissues after administration remains an unresolved question rather than an established finding.
Storage practice centres on limiting moisture, oxygen, and repeated temperature cycling. Freeze-dried powder is generally held desiccated at minus twenty degrees Celsius or colder and protected from light. Reconstituted solutions are markedly less stable, and the aspartate-glycine junction is prone to succinimide formation at neutral to mildly alkaline pH. Portioning material into single-use aliquots reduces degradation compared with repeated freeze-thaw cycles. Stability data specific to this tetrapeptide remain scarce, so most handling guidance is extrapolated from general peptide chemistry rather than measured directly.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Synthetic tetrapeptide, four residues |
| Nominal mass | Approximately 390 Da | Free peptide; salt forms differ |
| Appearance | White to off-white powder | Commonly supplied lyophilised |
| Solubility class | Freely soluble in water | Also dissolves in aqueous buffer |
| Typical storage | −20 °C, desiccated | Cold packs used during transport |
The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.
The proposed relationship between epitalon and pineal function is a central part of its background. Khavinson's group reported that short peptides corresponding to regions of larger pineal proteins could influence gene expression in cells. Epitalon was framed as a synthetic analogue of an active fragment rather than a direct isolation product. Whether the tetrapeptide reproduces the effects of the parent extract is an open question, because comparative studies are limited and the parent extract itself is not a single defined substance.
Reversed-phase high-performance liquid chromatography is the standard approach for assessing purity, usually with ultraviolet detection near 214 nm, where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the molecular mass and helps reveal truncation or deletion byproducts. Amino acid analysis can verify composition, and counterion content is sometimes measured because peptides purified with trifluoroacetic acid retain variable amounts of that salt. Purity figures reported without a stated method and detection wavelength are difficult to interpret.
Material sold for research use varies widely in documented quality. A useful verification package includes a certificate of analysis that states peptide content rather than only net weight, the chromatographic method and column used, and a mass spectrum consistent with the expected mass. Independent testing by a third-party laboratory is occasionally reported. Statements of identity resting only on a supplier label provide little assurance, and the gap between nominal mass and actual peptide content can be substantial once counterions and residual water are counted.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Reference material is normally supplied as a lyophilised powder in a sealed vial. Product literature typically recommends storage at minus twenty degrees Celsius or colder, protected from light and moisture. Freeze-thaw cycling is usually avoided because repeated condensation can introduce water into the vial. Working solutions are commonly prepared fresh, aliquoted, and kept cold for short periods rather than stored at ambient temperature. Labelling the date of opening helps track how long a vial has been in use.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
=== Federal jurisdiction === The act provided for federal court jurisdiction to enforce collective bargaining agreements. Although Congress passed this section to empower federal courts to hold unions liable in damages for strikes violating a no-strike clause, this part of the act has instead served as the springboard for creation of a "federal common law" of collective bargaining agreements, which favored arbitration over litigation or strikes as the preferred means of resolving labor disputes.
=== Metalloproteins === Metalloproteins are conjugated proteins that are characterized by having one or more metal ions attached to the protein as a prosthetic groups. These metal ions could be iron, zinc, copper, magnesium, etc., and these are very important to the biological functions and its protein activity. Metalloproteins are involved in a wide range processes from electron transfer to catalysis. Many enzymes are metalloproteins, since metal ions can act as cofactors in chemical reactions. For example, zinc ions can be associated with enzymes that are responsible for gene expression. Moreover, metalloproteins containing iron often are involved in oxygen transport and redox reactions. In this way, the presence of metal ions allows these proteins to perform certain tasks that would not be possible with amino acids alone.
Konrad Adenauer was 73 years old when he became chancellor in 1949, and for this reason he was initially reckoned as a caretaker. However, he ruled for 14 years. The grand statesman of German postwar politics had to be dragged—almost literally—out of office in 1963.
==== MeSH D12.776.503.280.249 – collectins ==== MeSH D12.776.503.280.249.500 – mannose-binding lectin MeSH D12.776.503.280.249.600 – pulmonary surfactant-associated protein a MeSH D12.776.503.280.249.625 – pulmonary surfactant-associated protein d
Sources: en.wikipedia.org
==== X-ray ==== X-rays are produced by bombardment of dense target material with high-energy accelerated electrons (this process is known as bremsstrahlung-conversion), giving rise to a continuous energy spectrum. Heavy metals, such as tantalum and tungsten, are used because of their high atomic numbers and high melting temperatures. Tantalum is usually preferred over tungsten for industrial, large-area, high-power targets because it is more workable than the latter and has a higher threshold energy for induced reactions. Like electron beams, X-rays do not require the use of radioactive materials and can be turned off when not in use. X-rays have high penetration depths and high dose uniformity but they are a very expensive source of irradiation as only 8% of the incident energy is converted into X-rays.
=== Pollution mitigation === In 1989, a researcher, Ken Simmons, introduced CaCO3 into the Whetstone Brook in Massachusetts. His hope was that the calcium carbonate would counter the acid in the stream from acid rain and save the trout that had ceased to spawn. Although his experiment was a success, it did increase the amount of aluminium ions in the area of the brook that was not treated with the limestone. This shows that CaCO3 can be added to neutralize the effects of acid rain in river ecosystems. Currently calcium carbonate is used to neutralize acidic conditions in both soil and water. Since the 1970s, such liming has been practiced on a large scale in Sweden to mitigate acidification and several thousand lakes and streams are limed repeatedly. Calcium carbonate is also used in flue-gas desulfurization applications eliminating harmful SO2 and NO2 emissions from coal and other fossil fuels burnt in large fossil fuel power stations.
===== Ophthalmic division innervation ===== Lacrimal nerve – conveys sensation to the skin areas of the lateral orbital (eye socket) region, except for the lacrimal gland. Frontal nerve – conveys sensation to the skin areas of the forehead and the scalp. Supraorbital nerve – conveys sensation to the skin areas of the eyelids, the forehead, and the scalp. Supratrochlear nerve – conveys sensation to the medial region of the eyelid skin area, and the medial region of the forehead skin. Nasociliary nerve – conveys sensation to the skin area of the nose, and the mucous membrane of the anterior (front) nasal cavity. Anterior ethmoid nerve – conveys sensation in the anterior (front) half of the nasal cavity: (a) the internal areas of the ethmoid sinus and the frontal sinus; and (b) the external areas, from the nasal tip to the rhinion: the anterior tip of the terminal end of the nasal-bone suture. Posterior ethmoid nerve – serves the superior (upper) half of the nasal cavity, the sphenoids, and the ethmoids. Infratrochlear nerve – conveys sensation to the medial region of the eyelids, the palpebral conjunctiva, the nasion (nasolabial junction), and the bony dorsum.
NAD-dependent deacetylase sirtuin 2 is an enzyme that in humans is encoded by the SIRT2 gene. SIRT2 is an NAD+ (nicotinamide adenine dinucleotide)-dependent deacetylase. Studies of this protein have often been divergent, highlighting the dependence of pleiotropic effects of SIRT2 on cellular context. The natural polyphenol resveratrol is known to exert opposite actions on neural cells according to their normal or cancerous status. Similar to other sirtuin family members, SIRT2 displays a ubiquitous distribution. SIRT2 is expressed in a wide range of tissues and organs and has been detected particularly in metabolically relevant tissues, including the brain, muscle, liver, testes, pancreas, kidney, and adipose tissue of mice. Of note, SIRT2 expression is much higher in the brain than all other organs studied, particularly in the cortex, striatum, hippocampus, and spinal cord.
=== Backwashing === In backwashing, the transmembrane pressure is periodically inverted by the use of a secondary pump, so that permeate flows back into the feed, lifting the fouling layer from the surface of the membrane. Backwashing is not applicable to spirally wound membranes and is not a general practice in most applications. (See Clean-in-place)
Sources: en.wikipedia.org
No. Epithalamin is a heterogeneous peptide fraction obtained from pineal gland extract and contains many components. Epitalon is a single synthetic tetrapeptide with the sequence Ala-Glu-Asp-Gly. Researchers synthesised the shorter peptide while attempting to identify active sequences within the extract.
No endogenous peptide with this exact sequence has been described as a circulating hormone or signalling molecule. The tetrapeptide was designed as a synthetic analogue based on fragments observed in pineal preparations. Any activity discussed in the literature therefore refers to administered material rather than to a natural pool of the compound.
It is not an approved medicine in major jurisdictions and does not appear in the major pharmacopoeias. Material is usually distributed as a research chemical or laboratory reagent. Such labelling places handling responsibility on the purchaser and does not indicate that a regulatory body has reviewed the substance.
Reversed-phase high-performance liquid chromatography with ultraviolet detection at 214 nanometres is the usual approach. Peak area percentage provides a purity figure relative to other components in the sample. Mass spectrometry is then applied to confirm identity.